Thread production by
helical interpolation within the pitch

JEL®  Thread milling cutters

 

In thread milling, the thread is produced by doing an helical interpolation. The cutting process
enables the production of threads from a nominal diameter of 1 mm (single profile), with
multi-profile from M2. Some tools are also equipped with countersinkers and/or face cutters. 

 

Your PLUS:

  • The thread depth is equal to the drill depth if tool is not used for chamfering
  • Lower torque than with tapping and roll form tapping
  • Short milling chips avoid chip problems
  • High Speed Cutting (HSC) possible


Range overview JEL®  Thread milling cutters:

JEL® MGF

JEL®  MGF
Ø: 2.0 to 20.0 mm
For defined thread lengths
of 1.5xD, 2xD, 2.5xD and 3xD
With shank-side chamfer

JEL® MGF XH

JEL®  MGF XH 
Ø: 3.0 to 16.0 mm
For defined thread lengths of
1.5xD with shank-side chamfer.
Thread milling direct into
hardened materials from 45HRC

JEL® MGF XH

JEL®  MGF XH MICRO
Ø: 1.0 to 2.5 mm
For defined thread lengths of
1.5xD with shank-side
chamfer. Thread milling
direct into hardened materials
from 45HRC

JEL® MGF XS

JEL®  MGF XS
Ø: 4.0 to 20.0 mm
For defined thread lengths of
1.5xD and 2xD. With shank-side
chamfer. For steel machining beginning from 900 N/mm² tensile strength

JEL® UMGF

JEL®  UMGF
Ø: 6.0 to 16.0 mm
For variable thread lengths
up to 2xD and 2.5xD
With face- and shank-side
chamfer


JEL® MKG

JEL®  MKG
Ø: 4.0 to 14.0 mm
Thread milling 2xD

 

 

 

 

JEL® GWF

JEL®  GWF TOMIL SR / XS
Ø: from 20.0 mm
Thread lengths up to 48 mm
possible. GWF XS for steel
machining beginning from 900 N/mm² tensile strength

 

JEL® GWF TOMILL

JEL®  GWF TOMILL GP
Ø: from 20.0 mm
With face-side chamfer and face milling cutter. Thread lengths up
to 45.0 mm possible

JEL® TOMILL CUT

JEL®  GWF TOMILL CUT
Ø: from 20.0 mm
Coarse picth threads up to M64,
2xD possible

 

 

 Thread Milling Machining Sequence

 

 
loading...